Portable Gazebo

I buy a house with a spa that is located in a sort of mobile kiosk about 50 meters from the house. Currently we are negotiating who gets the spa.

There is an electrical box outside the pavilion, which is fixed electricity to the spa and a ceiling fan. If they take the hot tub, what can I do about the breaker box just to stick in the yard? Any ideas of cost of removal? I can tell them to pay.

I think you should leave the breaker box in its place. Are you afraid of being electrocuted? This is no more dangerous than any other outlet.
If I buy this house, I do not want the spa, but I would like to use the breaker box to power my tools, and create a small workshop shed.
There you will have a good source of energy in your hangar. You can plug a heater in the shed and work on DIY projects in the shed, even in winter.
You'll also have a good place to plug in electric hedge trimmers.
It would also be a good place to load a motorcycle or lawn tractor Electric Power.

uncoupling of the box where it is fed by the circuit board and cut Outside son as far as you can the basement and burying give up. also reduce the son in the house disconnected from the fuse box off tag

Once you've isolated which cuts into your mailbox main controls of the sub-group ', you can uncheck the main line to reach the spa. Once you identify just the cut / off and discard.

This leaves you with an additional switch in your main mailbox.
or
You can use the power available under the panel to add emphasis or exterior lighting or a function w / water.

Be creative, it's spring!

Disconnect the main breaker. Make sure it is "dead" and remove it.

Hire an electrician. But my husband will tell you that my answer is always someone ---- Rental!

you need to disconnect the circuit breaker in your main panel. Check your main panel and find the right circuit breaker may be a 30 amp circuit breaker pole three, then take the son on the runway and land. your main panel will be hot so be careful or simply hire an electrical contractor

If I were in a situation like that? I'd probably
- Turn off power to the main box in the house and remove the breaker panel feeding in relevant,
- Remove the son of inside the main area and reduce the exit point, probably a hole in the wall ..
- Disconnect and remove the bottom panel and discard or reuse elsewhere,
- Dig pole
- Cut the son as far below the soil surface as possible
- Fill the hole and resod or grasspatch.

- Let the remnants of old cables in the ground, they go down to 18 "depending on your" code ". They do not bother anyone, and besides, they are disconnected from the main panel. Otherwise, if you wish, you can dig these suckers with a shovel, but why?

You are right. Winner Take All, or in this case, if they want the tub, they will remove the box and associated cables. If you really want the tub is a permanent fixture and they will be included in the sale.

Find the breaker that cuts power to the box spa ... Turn main power and remove the son of the breaker and remove the breaker .... put a label on them to let you know what they where for .. bands in place ..... let the old breaker box ..... remove the son of the box outside and dig there ... thats the elbow if it can be removed, remove .... Double bend the wire and push it back inside the ducts ... buy a cap if PVC conduit or get a metal cap if metal duct ... cover that part safeguard ..... if you do it this way and save all the accessories ... If for any reason you want to put the box back to resume a whirlpool in the future, you can easily.