Micro Grill

We all love the look of a truck grill brilliant, but when was the last time you paid any attention to yours? Most of us barely had time to make sure our schedule is looking good, we simply wash our truck and that's about it. We are constantly re taking care of our grill every spring and summer. But do not take care of your grill is really a disservice to your truck. By just taking a few minutes to take care of your grill, you can keep shining and research for many years to come.

Has it oxidized beyond the point of recognition? Want to see your face when you walk in front of your truck? Check out these tips and before you know it, your barbecue will be bright as the day you put a whole.

Start-up

First, clean the grill properly. Dust away from the surface contaminates or debris. If you can remove dirt, grease, dirt, and polishing your experience will go much easier. Use hot, soapy water for the initial cleaning, then once you have dried the grid, it grows with some degreaser. This should break the bad build you were looking for so long. Then dry again. Most trucks have a quiet build up on the grid if it can take a little work.

it is really clean

Pull the elbow grease for this step because you'll need. It is the most important step to get a burst much to our billet grille. Ultimately, the effort is worth the results.

First, the wet sand your grill with a 320 grit wet sandpaper. Keep the sandpaper wet and grill at all times during the process of sanding. You should not need to apply excessive pressure. In fact, to avoid too much pressure. Apply just enough to scrape up the grill. Keep your blood even further to produce sand. You should leave visible scratches to aluminum. Do not worry about them, if they come to the next step.

After 320 grit sandpaper wet, remove the paper 400 grit, then 600 grit paper, through the same process with each of them. Throughout this process, you will notice the aluminum becomes soft and shiny. With the grit sandpaper over your scratches will become less noticeable.

Late stage of sanding with 1000 grain sandpaper damp. This will get rid of scratches sensitive end and leave micro scratches. Take your time at this stage, and also sand and smooth your grill. You are finally working to get your grill truck strong research now is not the time to cut corners.

After sanding, wash the grid again with hot soapy water. After drying, wipe the grill down with a degreaser again to get rid of contaminants.

Finishing touches

Now you can bring that coveted glow back to your gate truck and make your vehicle the talk of all your friends. Apply your polish aluminum uniformly. Then use your polishing tool. Keep polishing your grill until the polish turns black aluminum. Once you have polished the entire grid, and it became dark, wipe it with a micro fiber towel to remove excess polish.

To enter the areas difficult to reach, use a small flathead screwdriver with a towel over microwave. Do not poke a hole through the briefcase. You can just scrape your grill.

With the excess polish is removed, you now have a clean grill. To remove fine scratches, rub the polish on your latex gloved fingers. To do this until the polish turns black.

Congratulations. You now have an impressive looking grill truck that all your friends will be jealous of!