Galvanized Fence Posts

I intend to build a wooden fence design Shadowbox with galvanized fence posts. I was told to spread the rails, so they find themselves at different points along the fence. How do I reach the end of the 2x4 rails together, mid-range? I was watching the Simpson material, but am not sure it is better to use. Thank you.

You do not have middle span joints, I think the intention was not to leave to end two 2x4 in the same position. I suppose you'll use 16 '2X4 rails and posts on 8' centers. I used all posts galvanized me, but I have the necessary supports at home Supply Depot, Lowes also had. After rebuilding my fence, I smartened and, like you, use galvanized steel posts. I would never use wood poles again.

Luther, I saw the material at Lowe's, which surrounds the position and connects to the rails. I had planned to run a bolt through the 2x4 and post, as I have seen many fences made this way. Would you recommend this? Thank you for the help. Flag

Use 4 tie 2by use self tapping screws to fasten metal to a metal post.

By staggering the tracks they want to say that they overlap to a pole on top of each other so they have good mount points. This works if you build the fence by zero, but not if you've found 8 foot sections.


wooden fence panels are attached to metal surveys using a U-shaped clip of fencing. To install the panels, a helper hold the panel in place. Next, place the clip U-shaped fences on the metal pole and the one piece of the vertical support panel. Screw in place with galvanized screws

you should not have seams middle span.