Fence Post Anchor

People build fences everyday and most are built correctly but most could also be built a little better. By applying the tips below unfamiliar, you can build a fence that will last longer and look better.

You start a fence by making holes spaced about every 8 feet apart for the 4x4x8 treated posts. These holes should be dug 2 feet deep with an auger. Most people stay there with a cylinder shaped hole since digging these holes is the most intense part of fence construction. To ensure the post is anchored to the fence installer should use the auger at an angle around the entire diameter of the hole to make a ball shaped anchor at the bottom of the bottle. A post hole dug in this way is much safer and more stable.

Another mistake people make is not the realization that the wooden sticks to concrete. Drive by any concrete work and you will notice they use wood forms to frame the concrete held in place by nails and wood stakes. The next day the concrete workers take the nails and the wood forms just fall off the concrete. Another problem is bugs and water in the soil can deteriorate the wood posts. To avoid these problems, the manufacturer of fence should put black roof tar on both feet down the fence post that has entered the field. This will prevent the post from rotting and allows the concrete to stick to the post.

After the posts are level and set you should let them dry for a whole day before nailing on them. If you start nailing on them before the concrete is completely set you hit level positions.

Many people build a fence with only two rails to nail their fence slats. To build a security fence that will last for years, three rails should be used. The top bar must be placed on top of fence posts located in a horizontal position. The slats of fence must not be installed more than 8 "above the top bar. If so they will tend to twist and turn with age. The bottom track shall not exceed 8 "above the bottom of the fence slats for the same reason. The center rail should be placed equally between the top and bottom rails. Although the top rail is placed in the horizontal position in the middle and the lower rail should be positioned vertically. This will prevent these rails to deform and made a much better looking and stronger fence.

Ask any roofer about water drainage and he will tell you that water always goes in one direction - and that is down. It is almost correct, but he does not understand the lip or stay factor. There is a case where water and can travel up, and every fence builder should be aware. It is also why the rot fascia boards almost always the chain.

Have you ever passed a house with wood siding or a wood fence and noticed the bottom of the painted wood is bubbling and rotten? The paint or wood coating should have protected the wood from moisture to prevent rotting, however, that the installers are not aware of the factor lip or stay.

Many contractors do not seal the bottom lip of the timber. Over the years that water flows down the face of the wood it lingers on the exposed bottom lip and begins to soak into the wood causing it to rot. If you want to water seal or paint your new fence, always certain to coat the upper and lower lips.